Modern graphics cards use lots of power and all of it is turned into heat. So if you’re paying many hundreds of dollars for a powerful GPU, you’d expect no expense to be spared on the cooling system. It turns out that for many Nvidia RTX 40-series vendors, the expense is being spared and cheap, poorly applied thermal paste is leading to scorching high hotspot temperatures and performance degradation over time.
That’s the conclusion hardware tester Igor’s Lab has come to after testing multiple GeForce RTX cards, analysing temperatures and performance, and discovering that the thermal paste used by many graphics card vendors is not only sub-standard for the job but is also poorly applied.
I have four RTX 40-series cards in my office (RTX 4080 Super, 4070 Ti, and two 4070s) and all of them have quite high hotspots—the highest temperature recorded by an individual thermal sensor in the die. In the case of the 4080 Super, it’s around 11 °C higher than the average temperature of the chip. I took it apart to apply some decent quality thermal paste and discovered a similar situation to that found by Igor’s Lab.
In the space of a few months, the factory-applied paste had separated and spread out, leaving just an oily film behind, and a few patches of the thermal compound itself. I checked the other cards and found that they were all in a similar state.
[…]
Removing the factory-installed paste from another RTX 4080 graphics card, Igor’s Lab applied a more appropriate amount of a high-quality paste and discovered that it lowered the hotspot temperature by nearly 30 °C.
But it’s not just about the hotspots. Cheap, poorly applied thermal paste will cause the performance of a graphics card to degrade over time because GPUs lower clock speeds when they reach their thermal limits. PC enthusiasts are probably very comfortable with replacing a CPU’s thermal paste regularly but it’s not a simple process with graphics cards.
[…]
While Nvidia enjoys huge margins on its GPUs, graphics card vendors aren’t quite so lucky, but they’re not so small that spending a few more dollars on better thermal paste isn’t going to bankrupt the company.
Mind you, if they all started using PTM7950, then none of this would be an issue—the cards would run cooler and would stay that way for much longer. The only problem then is that you’d hear the coil whine over the reduced fan noise.
Robin Edgar
Organisational Structures | Technology and Science | Military, IT and Lifestyle consultancy | Social, Broadcast & Cross Media | Flying aircraft